Page Comparison

...

1. Go to main interface panel (side of chalk board), push Power Button (top button). 
2. The select either HDMI (middle button) or VGA (bottom button). 
   
   
   
   
3. If using HDMI the audio will automatically pass from the computer to the speakers within the HDMI cable. 
   
   
   
   
4. If using VGA, the separate 3.5mm audio connection requires the VGA connection to be connected too.
   (On the wall side of the VGA cable there's a status light, where Amber = audio not connected, Green = audio connected)
   
   
   
   
   1. Plug VGA connection into device.
   2. Plug 3.5mm audio connection into device.
5. Audio volume is controlled by the volume controls control on the computerdevice. 

1. First, check out the Projector Key from the Human Resource Office. You will need this key to open up audio controls.

...