Page Comparison

...

1. Go to main interface panel (side of chalk board), push Power Button (top button). 
2. The select either HDMI (middle button) or VGA (bottom button). 
   Image Removedsource will automatically set itself once you plug the HDMI/USB-C cable into your device. 
3. Once connected via HDMI or wirelessly, you can control the room's audio with the audio controller.
   
   Image Added
   
   
4. If using HDMI the audio will automatically pass from the computer to the speakers within the HDMI cable. 
   Image Removed
   If using VGA, the separate 3.5mm audio connection requires the VGA connection to be connected too.
   (On the wall side of the VGA cable there's a status light, where Amber = audio not connected, Green = audio connected)
   Image Removed
   
   1. Plug VGA connection into device.
   2. Plug 3.5mm audio connection into device.
   Audio volume is controlled by the volume control on the device
   Image Added
5. When done presenting, please power off the projector by double pressing the power button at the top of the button panel to preserve the life of the projector bulb. 

If you need help, contact the Front Office at (858) 534-1927.

**************************************** D E P R E C A T E D ****************************************

...